In nearly all situations, most individuals spend quite a bit of money purchasing their lift truck. Therefore, it is very essential to take good care of it in order to protect your investment well into the long run. It is really a great idea to know the procedures which are undertaken during the care and maintenance of this piece of machinery.
By starting up the forklift and listening carefully how it runs is one of the best ways to tell how good the engine is performing. Like for example, if there are any knocks or misses, the machinery is faulty and this should raise several concerns. Moreover listen closely for any squealing noise that come from the belts as these sounds will provide you with a lot of information.
When performing maintenance, several of the main parts you would have to pay attention to consist of the horn, safety warning devices, the lights, the gauges and the overhead guard. Any faulty components or burnt out light bulbs must be replaced as soon as they are noticed. It is also imperative to check the wiring.
The battery compartment terminals should be cleaned after the above components have been inspected thoroughly. If the terminals are not clean, be sure to clean them properly. Each cell of the battery must be inspected so as to make sure that the fill level is topped up to the regulated amount.
The next step is to drain all of the oil out of the machine and after that change the filters. The hydraulic filter, the transmission filter and the fuel filters must be replaced on a regular basis. Before fitting them, be sure to write the date on the new filters by using a permanent marker in order to keep track.
When the oil change has been carried out and new filters have been fitted, visually check the drive axle from beneath the equipment. Be certain to grease the axle if there is any grease fitting. Check the engine belts for any cracks or frays. If you find any, fix the issue accordingly. Afterwards, inspect each and every other part of the equipment including the wheels. If any kind of fault or concern is detected, be certain to deal with it immediately so as to make sure the machinery is working at its safest and optimum levels.